PVC RV Rubber Roof Material in Gray - By The Foot
- Minimum Purchase:
- 5 units
- Maximum Purchase:
- 50 units
*DISCLAIMER: Roofing ships in a box; It's important to unpack roofing material as soon as possible to avoid creasing. *Minimum 5' Purchase
PVC roofing material is a state-of-the-art membrane that's engineered to provide the best performance possible for your RV roof. It's made out of an Olefin-based membrane that's only one ply, making the weight about half of that of EPDM roofing. It's flexible and stretchable and conforms to the contours of your RV. There are multiple RV manufacturers that currently use PVC as an alternative roofing material (Forest River, Crossroads, Northwood, and Outdoors RV)
Recommendation for installation
If one surface is porous (has small holes or spaces), such as plywood or fiberboard, it is recommended to wet laminate the membrane to the substrate. If both surfaces are non-porous, such as EPS or ISO, apply the adhesive to both surfaces 4-5 mils and allow to dry approximately 20-30 minutes, depending on conditions. Adhesive will turn from white to clear when it is dry. Apply membrane to the roof deck and roll or broom down sheet to assure 100% contact area.
Please note that when applying your PVC roofing membrane, apply the smooth side down and the textured side up.
**While this material is sold by the foot, RecPro can only ship up to 40' at a time. As an example, if you order 80', it will ship in two separate containers. Any orders over 40' please call our customer service to place the order**
- Size: 9 1/2' width
- Made in USA
- Does not chalk
- Install shiny side up
- Is .165 lbs/sq feet compared to EPDM at .29 lbs/sq foot
- Has a better puncture resistance than EPDM
- Has a non-skid surface for better traction
- Easily repairable
- Color: Light Gray
- Same color through entire substrate
- 100% solids sealant (will not shrink or crack)
- .028 Thick
To help with installation, we recommend using our RecPro 8010 RV Roof Adhesive.
Please note that when applying your PVC roofing membrane to apply the smooth side down and the textured side up.
**PLEASE NOTE** All fiberglass/Filon/flooring/PVC cuts are obtained from a master roll. This means the ends will have a rough edge and will be longer than the purchased cut length. This is done so the customer may cut the piece to exact specifications. Customer will make final cuts.