RecPro® Roofing
PVC RV Rubber Roof Material in Tan - By The Foot
- SKU:
- TPOSF-45-T
- Minimum Purchase:
- 5 units
- Maximum Purchase:
- 50 units
Description
*DISCLAIMER: Roofing ships folded in a box; It's important to unpack roofing material as soon as possible to avoid creasing. *Minimum 5' Purchase
PVC roofing material is a cutting-edge membrane designed to provide optimal performance for your RV roof. It's made out of an Olefin-based, one-ply membrane that weighs about half as much as EPDM roofing. Its flexibility and ability to stretch also allow it to conform to the contours of your RV. There are multiple RV manufacturers using PVC as an alternative roofing material (Forest River, Crossroads, Northwood, and Outdoors RV).
Recommendation for installation
If you are using a porous substrate, like plywood or fiberboard, wet laminate the membrane to it. If both surfaces are non-porous, like EPS or ISO, apply adhesive to both of them 4-5 mils thick and allow it to dry for 20-30 minutes (conditions permitting). The adhesive will turn from white to clear when it is dry. Roll out or brush down the sheet over the roof deck so that 100% contact is achieved between deck and sheet.
When applying your PVC roofing membrane, be sure to use the smooth side down and the textured side up.
**While this material is sold by the foot, RecPro can only ship up to 40' at a time. As an example, if you order 80', it will ship in two separate containers. Any orders over 40' please call our customer service to place the order**
Details:
- Size: 4 1/2', 8 1/2', 9 1/2' width
- Made in USA
- Does not chalk (will not turn the side of the unit gray)
- Install shiny side up
- Is .165 lbs/sq feet compared to EPDM at .29 lbs/sq foot
- Has a better puncture resistance than EPDM
- Has a non-skid surface for better traction
- Easily repairable
- Color: Tan
- Same color through entire substrate
- 100% solids sealant (will not shrink or crack)
- .028 Thick
To help with installation, we recommend using our RecPro 8010 RV Roof Adhesive.
Please note that when applying your PVC roofing membrane to apply the smooth side down and the textured side up.
**PLEASE NOTE** All fiberglass/Filon/flooring/PVC cuts are obtained from a master roll. This means the ends will have a rough edge and will be longer than the purchased cut length. This is done so the customer may cut the piece to exact specifications. Customer will make final cuts.